Metabo WE 14-150 Plus Operations Instructions download pdf (Page 10)

7 Operation, Switching On/Off

Always guide the machine with both

hands!

First switch on, then apply the tool to

the work piece!

It must be avoided that the machine

draws in additional dust and shavings.

When switching the machine on and off,

keep it away from dust deposits.

After switching off the machine, only

place it down when the motor has come

to a standstill.

In the case of VTC, TC electronic control:

the red electronic signal indicator (6) comes on

briefly when the machine is switched on.

Machines with slide-switch (1):

(Machines with the designation W... or WE...)

Switching on: slide the slide-switch (1) forward

until it engages.

Switching off: press the rear end of the slide-

switch.

Machines with switch lock

(Safety switch because it cannot be locked):

(Machines with the designation WEP...)

Do not carry or suspend the machine

by the trigger switch (9).

Switching on: slide the switch lock (8) in the

direction of the arrow and press the switch

trigger (9).

Switching off: Release the switch trigger (9).

Tools with switch trigger (9):

(Machines with the designation WP... or WPS...)

Switching on: slide the switch lock (8) in the

direction of the arrow and press the switch trigger

(9).

Switching off: Release the switch trigger (9).

Continuous operation:

(Machines with the designation WP...)

Switch on the angle grinder and slide the switch

lock (8) forward until it engages.

Switching off continuous operation:

Briefly press the switch trigger (9) and release.

Restart safety device

(only with VTC/TC electronic system):

If the mains connection is made with the angle

grinder still switched on or if the power supply is

restored after an interruption, the angle grinder

will refuse to start. The red electronic system

indicator (6) flashes. Switch angle grinder off and

then on again.

8 Operation, Setting Speed

(depending on equipment)

Set the recommended speed with the knurled

wheel (7).

Grinding disc, cutting disc, cup grinding

wheel: high speed setting

Brush: middle speed setting

Surface dressing discs: low to middle speed

setting

Apply only light pressure to the tool when working

at low speeds.

9 Operation, Fitting Tools

Before any tool changing operation,

always remove the plug from the mains

supply socket and check that the angle

grinder is switched off and that the

spindle has come to a halt.

Locking the spindle

Press in the spindle-lock button (2) and turn the

spindle by hand until the spindle-lock button can

be felt to engage in position.

9 8

ENGLISH

02_ENG_Nafta_7970_0207 18.12.2007 14:49 Uhr Seite 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments

Metabo WE 14-150 Plus Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Power tools Metabo WE 14-150 Plus