Instruction Manual
Mobile thermal drilling
© Copyright by Flowdrill GmbH Olbrichtstr.18 69469 Weinheim
5.7. Selecting the speed step and presetting the rotational speed
The speed step of the work spindle should be selected irrespective of the material and drill diameter
in accordance with the following Table:
* Tool design “long”
5.8. Selecting the rotation direction
Flowdrilling (FLOWDRILL) and Flowtapping (FLOWTAP): right turn.
For Flowtapping with right turn tapping, holding, and screwing out with left turn.
The presetting switch can only be operated during shutdown.
5.9. Positioning the work piece
Please secure the work piece to be machined in the vice firmly, horizontally and free of vibration.
Position the work piece such that you only drill between the jaws of the vice, never outside them.
Position the vice on the drill stand. In particular make sure that you only drill perpendicularly to the
surface. For circular tubes please pay special attention so that you only drill on the uppermost point of
the round tube.
Comments to this Manuals