Metabo SBE 1010 PLUS Instruction Manual download pdf (Page 6)

Instruction Manual

Mobile thermal drilling

4. Preparation

For the proper functioning of the Flow2go unit when thermal drilling and for industrial safety

reasons, the following must be taken into account:

4.1. Mounting the handles on the drill base

Please screw the 3 handles enclosed fully up to the stop in the openings provided for this purpose on

the capstan shaft.

4.2. Mounting the tool holder

Only the enclosed tool holder (see Figure)

should be used for thermal drilling. To use

it the three-jaw chuck pre-mounted on the

drill must first be removed. For this fully

unscrew the drill chuck and while holding

up the spindle unscrew the inner retaining

screw (where present) with a suitable

screwdriver to the right (N.B.: left-hand thread!). Please refer to the instructions for using the drill for

further information.

Retaining screw with left-hand thread.

The tool holder must be screwed on fully and firmly tightened. Then the tool holder must also be re-

secured from inside with the enclosed short retaining screw.

Always use only tools and accessories that are in perfect condition!

The tool shafts must be in perfect condition and free of contaminants. They must not show any signs

of damage.

The collet in the tool holder should be carefully checked before using a drill and if necessary cleaned

or in case of damage replaced.

Mobile connecting leads should not be stretched under tension. All damage should be avoided as this

may cause danger due to the electric current. Do not use the drill if the connecting leads are damaged.

First have the equipment repaired by an authorised specialist firm.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

No comments

Metabo SBE 1010 PLUS Instruction Manual Page 6