Metabo SBE 1010 PLUS Instruction Manual download pdf (Page 14)

Instruction Manual

Mobile thermal drilling

12

© Copyright by Flowdrill GmbH  Olbrichtstr.18  69469 Weinheim

7. Trouble shooting

Problem

Cause

Remedy

Motor does not start

- No mains voltage

- Rotation direction not selected

- Switch not clearly positioned

- Switch or lead faulty

- Carbon brushes worn (observe flashing

light!)

- Check mains voltage

- Preset rotation direction

- Have switch or lead replaced

- Have carbon brushes replaced

Motor running, but the spindle

does not rotate

- Switch is not clearly positioned

- Check and correctly set switch position

Motor stops when drilling

- Contact pressure too high

- Electronics switch off automatically

- Reduce contact pressure

- Wait a short time, then start again

Drilling not possible in spite of

correctly set rotational speed

- Tool also rotates in the collet

- Material thicker than permitted

- Re-clamp tool

- Replace collet

- Use thinner material

Workpiece and/or vice is raised

when flowtapping

- Workpiece clamping not sufficient

- Vice not secured

- Re-clamp workpiece

- Secure vice

Flowtap gets stuck

- Thermal drill hole not completely

tapped (material too thick)

- Bush/bush length too conical

- Lack of lubrication

- Fully tap bush

- Manually unscrew tool

- Use thinner material

- Lubricate tool

Tool holder rotates with left turn

of the spindle

- Retaining screw missing or is not firmly

tightened

- Tighten or reorder retaining screw

Drill is pushed upwards out of

the clamp during drilling

- Clamping screw not tightened

-Tighten clamping screw

The feed is very difficult to

access without drilling

- Foreign bodies between the guides

- The pre-tensioning of the guide is too

high

- Remove contaminants (dirt, chips etc.)

- Re-adjust the guide system in accordance

with maintenance instructions

The slide moves downwards on

its own due to its own weight

- The pre-tensioning of the guide is too

low

- Re-adjust the guide system in accordance

with maintenance instructions

1 2 ... 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments