Metabo SBE 1010 PLUS Instruction Manual download pdf (Page 11)

Instruction Manual

Mobile thermal drilling

Please ensure that the component surface is dry or when in the drilling position and is

free of water/oil and other strong contaminants. Do not use any unauthorised

lubricants or releasing agents for thermal drilling on this mobile drill base! Our special

releasing agent FDKS is available as an option for thermal drilling.

NOTE

5.13. Flowtapping with Flowtap

 Change the tool and replace the Flowdrill with the Flowtap.

To hold the optionally available M4 flowtap you require a (further smaller) collet of type

ER16Ø4mm that is available as an accessory.

NOTE

 Set the required rotational speed (tortoise + A = approx. 150min

-1

 Position the Flowtap accurately over the drill hole.

 Position the component and the vice.

 Lubricate the Flowtap well before each use with FTMZ and press lightly into the material. The

Flowtap rotates automatically.

 Always guide the process when moving in and out by hand. If possible the full operating range of

the Flowtap should be used. Take into account here the maximum possible penetration depth.

 Stop the unit and now change the direction of rotation of the spindle to LEFT TURN and press the

pushbutton again. Guide the removal of the Flowtap by hand.



TIP 1: To stop the flowtap promptly when inserting do not lock the pushbutton but

keep the button pressed with your hand.



TIP 2: Alternatively you can also use the Flowtap in a high-performance battery

operated drill and low speed step and insert the Flowtap by guiding it freely.



TIP 3: You will obtain optimum starting values and load capacities with (grease- or oil-

free) taps that are then cleaned.

Special flowtap oil FTMZ

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Metabo SBE 1010 PLUS Instruction Manual Page 11