Metabo Spindle Moulder TF 100 M Operations Instructions download pdf (Page 9)

14.5 Making Tenons

Tenons and grooves in end grain must only be made with the workpiece firmly held and guided by the sliding

carriage TF 100, available as optional accessory.

To complete the tenon, turn work-

piece over by 180° and make another

pass.

Install table extension according to

the instructions provided. Set tool,

fence and guard as required.

Set the backstop as required. Start machine. Place workpiece on

the table and against the backstop,

then push forward against the fence

into the rotating tool.

14.5 Set-In Work

15 Care And Maintenance

Always disconnect from power before servicing.

Danger of severe personal injury if machine is started unintentionally.

- Lubricate all moving parts regularly with a few drops of motor oil.

- Clean table and fence plates regularly, keep resin-free.

Start machine. Feed work slowly and

with a steady motion against the rota-

ting tool. When the pass is completed

pull the sliding carriage back to its

starting position.

Place workpiece on the sliding carria-

ge's table and secure with the clam-

ping arm. Lower the holddown shoe

as much as possible to cover the

space between the fence plates above

the tool.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Metabo Spindle Moulder TF 100 M Operations Instructions Page 9