Metabo Spindle Moulder TF 100 M Operations Instructions download pdf (Page 8)

13.6 Cutter Guard Setting

Loosen starknob (C) and set holddown

shoe onto the workpiece.

Adjust downward pressure with star-

knob (D).

After loosening starknob (E) set spring

guide against the workpiece.

14.4 Moulding Boards

- Mount tool as per section 13.2.

- Set/check spindle speed as per

section 13.3.

- Adjust spindle and fence as per

sections 13.4 and 13.5.

- Remove the cutter guard's pres-

sure spring.

- Set holddlown shoe as described

in section 13.6.

- Start machine and feed the work-

piece with a steady motion slowly

against the rotating tool.

Caution!

Always feed with a pushstick if the workpiece width is less than 120 mm.

Caution!

Switch machine off and let tool come to a complete stop before making any adjustments.

14.3 Moulding Strips

Important!

Always use a pushblock to feed the

work when near the end.

- Mount tool as per section 13.2.

- Set/check spindle speed as per

section 13.3.

- Adjust spindle and fence as per

sections 13.4 and 13.5.

- Adjust cutter guard as per section

13.6 to accommodate the

workpiece.

- Start machine and feed the work-

piece with a steady motion slowly

against the rotating tool.

14.2 Stock Prechecking

- Grown timber should be planed prior to any moulding operation.

- Do not work stock that is warped, bend or otherwise does not rest fully over its full length on the table and/or

against the fence plates.

14 Operation

14.1 Tools

This spindle moulder model TF 100 M must only be operated with tools having chip limitors for reduced kickback

and approved for manual feed, e.g. BG-TEST tools or equivalent.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments

Metabo Spindle Moulder TF 100 M Operations Instructions Page 8

Comments to this Manuals

Related products and manuals for Power sanders Metabo Spindle Moulder TF 100 M