Metabo Spindle Moulder TF 100 M Operations Instructions download pdf (Page 10)

U.K. Supplement to Operating Instructions for metabo

TF 100 M Spindle Moulder

Please note the following supplementary information associated with this machine:

U.K. Legislation and Codes of Practice

When used industrially within the U.K. this machine falls under the scope of:

- Woodworking Machines Regulations 1974

- Use and Provision of Work Equipment Regulations 1992

We strongly advise you study and follow these regulations.

Section 7.1 1-Phase Power Supply

230 V motor. Although the motors supplied with this machine will run safely on a 13A domestic ring main, on

starting the machine a high current of very short duration is drawn, which could cause your 13A fuse to blow. If

this persists we recommend to have the machine connected to a 16A separate radial circuit. Ensure a suitably

sized fuse matching the motor is used.

This work should be undertaken only by a qualified electrician!

If the plug, fitted to the power cable supplied with the machine, has to be changed or replaced, connect the mains lead

conductors in accordance with the following colour code.

Single-phase motors (110/115/220/230/240 volts):

Yellow/green - Earth

Blue - Neutral

Brown - Live

Three-phase motors (220/380/400/415 volts):

Machines with a 3-phase motor are connected to power mains using a 5-pin industrial appliance-inlet/connector

according to

VDE 0623/BS 4343/IEC 309.

4-wire mains lead Yellow/green - Earth

Brown - Phase (L1)

Black - Phase (L2)

Blue - Phase (L3)

5-wire mains lead Yellow/green - Earth

Brown - Phase (L1)

Black - Phase (L2)

Black - Phase (L3)

Blue - Neutral

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN!

Warning: This appliance must be earthed!

Wiring Instructions

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

No comments

Metabo Spindle Moulder TF 100 M Operations Instructions Page 10