Metabo HC 410 User Manual download pdf (Page 25)

15.1 Planer Blade Removal

For removal and installation of planer

blades lift both planing beds up.

Loosen all 6 locking screws of the

cutterblock wedge with a 10 mm open

end spanner (turn clockwise).

The blade and the cutterblock wedge

can now be lifted from the cutterblock.

15.2 Checking Planer Blade Setting

To check the correct outfeed table setting, place a straight edge, ruler or a planed batten on the outfeed table and across

the cutterblock. Slowly turn cutterblock by hand. The blade must lift the straight edge/ruler and pull it forward by 5 - 10

mm. Mark start and stop position of ruler with pencil on table. Carry out this check on the left and right side of each of

the three blades. For a safe operation of this planer/ticknesser it is important that the installation and checking of the

blade table setting is carried out very carefully (risk of accident and personal injury to the operator.

To assist in manually turning the

cutterblock, remove the lid and place

a 24 mm socket wrench on the

cutterblock nut (wrench not supplied

with the tool set).

Note: The blades must have a minimum width of 22 mm.

Smaller blades can not be securely locked. The cutterblock wedge locking

screws must be tightened to a max. torque of 9 Nm. Applying more torque

may strip the threads. Use only the spanner supplied wit tool set to tighten

the locking screws.

16 Care and Maintenance

16.1 Lubrication

The thicknesser bed column has a

lubricator nipple. Lubricate at least

once a year.

Regularly apply a few drops of oil to

the planing bed hinges and to all other

moving parts.

Lubricate feed roller bearings with a

few drops of oil, as required, but at

least once a year.

Max. planerblade projection over the

cutterblock is 1.0 mm.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

No comments

Metabo HC 410 User Manual Page 25