Metabo BKS 400 Operations Instructions download pdf (Page 5)

Attach mitre scale to segment using 3 each

tapping screw 3.9x9.5

washer 4.3

Place mitre fence segment onto carrier and

screw fitting bolt through segment into glide

piece.

Hardware:

fitting bolt SW 19x42

spring washer 12

plastic glide piece with threaded bush.

Place wave spring washer onto fitting bolt and

plastic glide piece into mitre fence carrier.

7.0 Mitre Fence Assembly

Bolt guide rod brackets to front and rear of

table. Use 4 each

hex. head bolt M8x16

hex. nut M8

Slide both plastic guide bushes onto guide rod,

then bolt guide rod to brackets. Use 2 hex.

head bolts M8x20.

Bolt mitre fence carrier to guide bushes. Use 8

raised countersunk tapping screws 4.8x22.

Install adjustable backstop on mitre fence seg-

ment. Hardware:

1 hex. head bolt M6x20

2 hex. nut M6

1 washer 6.4

Screw vernier scale to vernier scale carier with

2 each raised countersunk head tapping screw

2.9x6.5

Screw vernier scale carrier to mitre fence car-

rier with raised countersunk head tapping screw

4.8x13

Place guard support into guard support brak-

ket. Align with blade and riving knife and to

exact 90 against the table by moving the not

yet fully tightened guard support bracket. Tigh-

ten.

Note: An improperly set up guard support may

cause personal injury to the operator.

Install the hex. socket head screw holding the

push stick to the front left leg. Hardware:

1 hex. socket head screw M6x30

2 each hex. nut M6

Install bolt for holding the rip fence to front right

leg. Use hex. nut M8 and bolt M8

Cross cuts and mitre cuts must not be carried out without a suitable cross-cutting attachment (sliding carriage or

mitre fence).

If no mitre fence is installed use the Sliding Carriage stock-no. 091 000 06665.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Metabo BKS 400 Operations Instructions Page 5

Comments to this Manuals

Related products and manuals for Circular saws Metabo BKS 400