Metabo BW 750 Operations Instructions download pdf (Page 15)

15

ENGLISH

7.2 Saw storage

ADanger!

Store saw so that

 it can not be started by unauthor-

ized persons, and

 nobody can get injured.

A

Caution!

Do not store saw unprotected

outdoors or in damp environment.

To keep the saw blade from rusting,

spray with Cleaning and Maintenance

Spray (optional accessory) before stor-

ing it for a longer time.

7.3 Maintenance

Every 50 hours of operation

Check all screwed connections, tighten if

necessary (Rocker and rocker stop must

remain movable).

Check saw blade for firm seat, wear and

sharpness.

Remove any deposits that may have

build up inside the saw blade cover.

For special tasks the following accesso-

ries are available at your specialised

dealer – see back cover for illustrations:

A Saw blade

EL 700 x 3.2 x 30 56 KV

Standard saw blade

B Saw blade

CV 700 x 3.2 x 30 56 KV

Chrome-vanadium saw blade

C Saw blade

HW 700 x 4.2/3.2 x 30 42 F

High-alloy tungsten carbide tipped

saw blade; especially for hard

woods and an extended edge life.

ADanger!

Repairs to electric tools must only be

carried out by qualified electricians!

Electric tools in need of repair can be

sent to the service centre of your coun-

try. Refer to the spare parts list for the

address.

Please attach a description of the fault to

the electric tool.

The machine's packing can be 100%

recycled.

Worn out electric tools and accessories

contain considerable amounts of valua-

ble raw and plastic materials, which can

be recycled.

These instructions are printed on paper

produced with elemental chlorine free

bleaching process.

ADanger!

Before carrying out any fault service

or maintenance work, always:

 Switch machine OFF

 Unplug power cable

 Wait for saw blade to come to

standstill.

Check that all safety devices are

operational again after each fault

service.

Motor does not run

No mains voltage:

 check cables, plug, outlet and mains

fuse.

Mains voltage too low:

 use power supply cable of sufficient

lead cross section (see "Technical

Specifications").

No-voltage release solenoid tripped by

temporary power failure:

 switch on again.

Overload protection tripped:

let motor cool down for approx. 10 min-

utes, then start motor again.

Motor locked, e.g. by a blocked saw

blade:

 remove cause for blocking, let motor

cool down if necessary, then start

motor again.

Wrong rotational direction of saw

blade

Phase sequence changed at the phase

changer:

 Change direction of rotation (see

"Mains Connection").

Poor cutting performance

Saw blade dull (burn markings on the cut

edges):

 have saw blade resharpened or

replace it (see "Maintenance").

Set of teeth insufficient:

 have teeth properly set or replace

saw blade (see "Maintenance").

Saw blade soiled by resin:

 clean saw blade (see "Mainte-

nance").

Wood is too wet:

 let wood dry before cutting.

8. Available Accessories

9. Repairs

10. Environmetal Protection

11. Troubleshooting Guide

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 54 55

Comments to this Manuals

No comments