Metabo 1600 W User Manual download pdf (Page 7)

Important Information

on Initial Commissioning

Since an anti-corrosion agent is added in the final inspection stage for quality assurance

purposes, the machine may still contain traces of residue. Therefore, carry out the following

steps to ensure uninterrupted operation and a long service life.

1. Remove the water filler screw

2. Fill with clean water until the pump is full

3. Screw in the water filler screw

4. Open the pressure line (water tap)

5. Switch on the pump and allow it to run for approx. 1 min

6. Switch off the pump and disconnect the mains plug

7. Open the water filler and drain screw and allow the remaining water to drain

out via the water drain screw

8. Screw in the water drain screw

9. Fill with clean water until the pump is full

10. Screw in the water filler screw

11. Slightly open the pressure line (water tap)

12. Connect the mains plug and switch on the pump

13. Repeat the steps again, if required

Failure to observe these technical instructions may lead to foaming in the machine. This

prevents the intake of water to the pump. If no water is supplied, the pump is not switched

off and the resulting high temperature of the water in the pump head may damage the

pump. Caution: Danger of hot water escaping from the pump!

The anti-corrosion agent is classified as harmless to humans, animals and the environment!

The manufacturer cannot be held liable for damage resulting from failure to observe the

operating instructions or this supplementary sheet!

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Metabo 1600 W User Manual Page 7