| 73
KHE 75
CODE!
KHE 96
Comparative device characteristics
Torque 65 Nm
Drilling capacity in
- Concrete with hammer drill bits 45 mm
- Concrete with router bits 80 mm
- Concrete with TCT bits 100 mm
- Masonry with TCT bits 100 mm
No load speed 140 - 280 /min
Rated input power 1.150 W
Output power 690 W
Rated load speed 280 /min
Maximum impact rate 2.650 /min
Maximum single-blow energy 10 J
Collar diameter 58 mm
Bit retainer SDS-max
Weight (without mains cable) 6,4 kg
Standard equipment Side handle, drilling depth
guide, lubricant for tool shank
end, duster, carry case
Type KHE 75
Order no. 6.00275
EQUIPMENT FEATURES
Electronic Combination Hammer
KHE 75
Suitable for bits and accessories with SDS-max shank end
With the appropriate accessories, it is also suitable for bits
and accessories with spline shank or ratio thread
Rotation stop
Metabo CODE! System: electronic anti-theft system,
activated by CODE! key (accessory)
Vario Tacho Constamatic (VTC) full-wave electronics
Thumbwheel for preselection of speed
Pneumatic high-performance hammer mechanism
Magnesium die cast gear housing
Dust seal protects from the finest dust particles
Ergonomic housing design for fatigue-proof operation
Rubber-coated handle
Torque limiting clutch
No-volt release switch
Auto-stop carbon brushes
Brush wear indicator
COMBINATION HAMMERS
Comparative device characte-
ristics
Torque 120 Nm
Drilling capacity in
- Concrete with hammer drill bits 50 mm
- Concrete with router bits 80 mm
- Concrete with TCT bits 150 mm
- Masonry with TCT bits
No load speed 125 - 250 /min
Rated input power 1.700 W
Output power 850 W
Maximum impact rate 1.950 /min
Maximum single-blow energy 27 J
Collar diameter 73 mm
Bit retainer SDS-max
Weight (without mains cable) 11,8 kg
Standard equipment Metabo VibraTech (MVT)
side handle, drilling depth
guide, lubricant for tool
shank end, duster,
carry case
Type KHE 96
Order no. 6.00596
EQUIPMENT FEATURES
Suitable for bits and accessories with SDS-max shank end
With the appropriate accessories, it is also suitable for bits
and accessories with spline shank or ratio thread
Easy to hold in all working situations: three rubber-coated
handles always ensure an optimal holding position
Metabo VibraTech (MVT): reduced vibration levels and
therefore less impact on joints due to the integrated
damping system on the handles
Additional handle can be fitted to three places
on the housing
The adjustable front handle can be rotated 360°
and the angle adjusted
Long, slim design for an upright working position when
performing tasks at ground level
Rotation stop
Vario Tacho Constamatic (VTC) full-wave electronics
Thumbwheel for preselection of speed
Electronic soft start for precise spot-drilling
Die cast aluminium gear housing
Torque limiting clutch
Chisel can be fixed in 16 positions
Auto-stop carbon brushes
Brush wear indicator
Electronic Combination
Hammer KHE 96
NEW
ANGLE GRINDERSMETAL PROCESORSHAMMERSIMPACT DRILLSDRILLSSCREWDRIVERS
WOOD SANDING
MACHINES
ROUTERS
AND PLANERS
(98 pages)
(60 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals