Metabo SBE 561 Use and Care Manual download pdf (Page 7)

ENGLISH

ENG

imperial threads into steel)! The screw head may

break or a high reverse torque may build up.

The machine produces powerful forces when

seizing or catching the workpiece. Always hold the

machine firmly, adopt a steady stance and focus

on your work.

Secure small workpieces. For example, clamp in a

vice.

SYMBOLS ON THE TOOL:

.......Class II Construction

V...........volts

A...........amperes

Hz.........hertz

BPM.....beat per minute

..........alternating current

See page 3 (please unfold).

1 Chuck key (for geared chuck) *

2 Geared chuck *

3 Futuro Plus keyless chuck *

4Depth stop *

Additional handle *

6 Direction switch *

7 Sliding switch for normal drilling/impact

drilling *

8 Lock button (continuous operation)

9Trigger

10 Speed preselection wheel *

* depending on the features / model

Before plugging in, check to see that the

rated mains voltage and mains frequency,

as stated on the rating label, match with your

power supply.

SBE 561, SBE 521, BE 561:

Make sure the chuck clamps securely:

After drilling for the first time (clockwise), firmly

tighten the safety screw inside the chuck using a

screwdriver. Caution: left-handed thread! (see

Section 6.8)

5.1 Attaching the Additional Handle

(SBE 561, SBE 521, SB 561)

For safety reasons, always use the addi-

tional handle supplied.

Open the clamping ring by turning the additional

handle (5) anticlockwise. Push the additional

handle onto the collar of the machine. Insert the

depth stop (4). Securely tighten the additional

handle at the angle required for the application.

6.1 Adjusting the Depth Stop

(SBE 561, SBE 521, SB 561)

Loosen the additional handle (5). Set depth stop (4)

to the desired drilling depth and retighten addi-

tional handle.

6.2 Switching On and Off

To start the machine, press the trigger switch (9).

SBE 561, SBE 521, BE 561: Press in the trigger

switch to change the speed.

For continuous operation the trigger switch can be

locked using the lock button (8). To stop the

machine, press the trigger switch again.

In continuous operation, the machine

continues running if it is forced out of your

hands. Therefore, always hold the machine

with both hands using the handles provided,

stand in a safe position and concentrate.

6.3 Speed Preselection

(SBE 561, SBE 521, BE 561)

Select the (10) maximum speed using the prese-

lection wheel. See page 4 for recommended

drilling speeds.

6.4 Switching Between Normal Drilling/

Impact Drilling

(SBE 561, SBE 521, SB 561)

Select the desired operating mode by pushing the

sliding switch (7).

Drilling

Impact drilling

Work with high speed settings when impact

drilling.

Impact drilling and normal drilling only in a

clockwise direction.

6.5 Selecting the Direction of Rotation

(SBE 561, SBE 521, BE 561)

Do not activate the direction switch (6)

unless the motor has completely stopped.

4Overview

5 Commissioning

6Use

17026862_1007 NAFTA SBE BE 561 521 ff.book Seite 7 Donnerstag, 25. Oktober 2007 2:11 14

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Metabo SBE 561 Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Metabo SBE 561