Metabo SBE 1100 Plus Use and Care Manual download pdf (Page 8)

ENGLISH

ENG

6.1 Assembly of additional handle (2)

For safety reasons, always use the additional

handle supplied.

Open the clamping ring by turning the additional

handle (2) counter-clockwise. Push the additional

handle onto the collar of the machine. Insert depth

stop

(3)

. Slide the additional handle far enough

forward so that it can be turned. At the desired

angle, pull it back and tighten firmly.

7.1 Adjusting depth stop

Release additional handle (2). Set depth stop

(3)

the desired drilling depth and retighten additional

handle. (2)

7.2 Setting direction of rotation, transport

lock (switch-on lock)

(except SB 710)

Do not activate the rotation selector switch

(11) unless the motor has completely

stopped.

See page 3 (please unfold).

R = Clockwise setting

L = Counter-clockwise setting

0 = Central position: transport lock setting

(switch-on lock)

The drill chuck must be firmly screwed onto

the spindle and the safety screw inside the

drill chuck (if applicable / model-specific) must be

firmly tightened with a screwdriver. (Caution, left-

handed thread !) If rotated counterclockwise (e.g.

when screwing) it could otherwise become loose.

7.3 Setting up drilling, impact drilling

Press the slide switch (7).

= Impact drilling

= Normal drilling without impact

Note:

Impact drilling and drilling, only in clock-

wise direction

Note:

When impact drilling, use a high speed:

Select 2nd gear on thumbwheel (1).

7.4 Selecting a gear

Select the desired gear by turning the thumbwheel

(1)

Change speed only when the machine is in the

process of running down (briefly switch it on and

off).

1st gear (low speed, high torque) e.g. for

screwdriving, drilling

2nd gear (high speed) e.g. for drilling, impact

drilling

7.5 Preselect speed

(except SB 710, SBE 701 SP, SBE 710,

SBE 751)

Use the setting wheel (8) to preselect the

maximum speed. See page 4 for recommended

drilling speeds.

7.6 Setting up torque control

(SBE 900 Impuls)

Set using setting wheel (9) (position 1 - 6). When

the preselected torque is reached, the motor

stops.

= When a low torque is reached, the motor

stops.

= When a high torque is reached, the motor

stops.

= Drill setting - not torque control (for max.

torque)

7.7 Switching on impulse function

(SBE 900 Impuls)

Set using setting wheel (9).

= Impulse function always switched on

= Impulse function off (for drilling)

7.8 Switching on/off, changing speed

Switching on, speed:

press the trigger (13).

The speed can be changed by pressing in the

trigger.

The electronic soft start means that the

machine accelerates continuously until the

preselected speed is reached (depends on

equipment).

Release the trigger to switch off.

Continuous activation:

While pressing on the

trigger (13), press in the locking button (12) and

then release the trigger. To switch off, press

and release the trigger (13) again.

In continuous operation, the machine

continues running if it is forced out of

7Use

17026970_0511 SB_Bauk10 NAFTA.book Seite 8 Freitag, 13. Mai 2011 8:38 08

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Metabo SBE 1100 Plus Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Metabo SBE 1100 Plus