Model No. 10013305 Stock-no. 115 107 8059Assembly/Operating InstructionsSite Saw BKS 400/BKS 450
10.3 Cutting WedgesA - Place work firmly into wedgecutting jig and set to desired angle.- Start machineB - Push mitre fence forward to feedwork into b
U4BA_M1.FMAchtung! Diese Seite ersetzen durch „ More of metabo- tools “Attention!Please replace this page by „ More of metabo - tools “
Contents 1.0 Scope of Application 2.0 Specifications 3.0 User Responsibility 4.0 Standard Accessories 5.0 Optional Accessories 6.0 Assembly 7.0 Mitre
NoteWithin the U.K., this machine falls under the Woodworking Machinery Regulations 1974, under which certainoperations, e.g. grooving, rebatting, ten
Place both support struts onto the table, setsquare with the slot of the table insert and boltto the table. Use 10 eachcountersunk screw M6x16,hex. n
Attach mitre scale to segment using 3 eachtapping screw 3.9x9.5washer 4.3Place mitre fence segment onto carrier andscrew fitting bolt through segmen
Place carriage bolt M10x30 from underneaththrough carrier and slot of fence segment.Install washer Ø 10.5 and ratched lever M10female.Install 0° (90°)
8.4 Switch/Motor Protection/Motor BrakeThe magnetic switch does not engage if not connectedto power mains. It disengages in the event of a powerfailu
Set rip fence to required width of cut. Distance from bladeis shown on the rip fence scale.Loosen scale fixing screw to adjust rip fence scale to give
10.1 Ripping/Through Sawing10.0 CuttingHave riving knife and blade guard inplace - danger of injury.Set blade guard to thickness of work-piece.Set rip
Comments to this Manuals