Metabo Power 260 User Manual download pdf (Page 10)

10

ENGLISH

After all servicing:

− Check to see that all safety

devices are operational.

− Make sure that no tools or other

parts remain on or in the device.

Compressor does not run:

• No mains voltage.

− Check cables, plug, outlet and

mains fuse.

• Mains voltage too low.

− Use only extension cables with

sufficient lead cross section (see

"Technical Specifications"). Avoid

using extension cable with cold

device.

• Compressor was stopped by

unplugging.

− Switch compressor OFF at the

On/Off switch, then ON again.

• Motor has overheated, caused by

insufficient cooling (cooling fins

covered).

− Remove cause for overheating

and allow to cool down for

approx. 10 minutes, then start

again.

Compressor runs but does not build

up sufficient pressure.

• Condensate drain of pressure ves-

sel leaky.

− Check gasket of drain screw(s);

replace if necessary.

− Tighten drain screw(s) fingertight.

• Check valve leaky.

− Have check valve serviced by

qualified service centre.

Air tool is not supplied with sufficient

pressure.

• Pressure regulator not opened wide

enough.

− Open pressure regulator more.

• Hose connection between compres-

sor and air tool leaky.

− Check air hoses, replace defec-

tive parts if necessary.

A

Danger!

Repairs to power tools must be

carried out by qualified electricians

only!

Electric tools in need of repair can be

send to the service centre in your coun-

try. See spare parts list for address.

Please attach a description of the fault to

the power tool.

The device's packaging can be 100 %

recycled.

Worn out devices and accessories con-

tain considerable amounts of valuable

raw and plastic materials, which can be

recycled.

These instructions are printed on chlo-

rine-free bleached paper.

7. Repairs

8. Environmental Protection

9. Technical Specifications

Suction capacity l/min 235

Free air delivery (volume flow rate) l/min 110

Filling rate l/min 120

Max. working pressure bar 8

Pressure vessel volume l 4

Pump model F 245

No. of cylinders 1

Motor speed min

-1

2850

Motor capacity kW 1.5

Supply voltage (50 Hz) V 230

Rated current A 6.8

Fuse protection min. A 10 (time-lag)

Degree of protection IP 20

Maximum overall length when using extension cables with:

– 3 x 1.0 mm

2

lead cross-section

– 3 x 1.5 mm

2

lead cross-section

– 3 x 2.5 mm

2

lead cross-section

m

m

m

10

25

25

Dimensions: length x width x height mm 600 x 310 x 405

Weight kg 18

Sound pressure level at 1 m max. dB (A) 87 ± 3

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comments to this Manuals

No comments