Metabo Multi 180A User Manual download pdf (Page 2)

4

ENGLISH

1.1 Specified Conditions of

Use

This dust collector is intended for the

extraction and collection of saw dust and

chips, which are generated when work-

ing wood or wood-derived materials.

Any other use is not as specified. Use

not as specified, alteration of the

machine or use of parts that are not

approved by the equipment manufac-

turer, can cause unforeseeable damage!

1.2 General Safety

Information

Read and follow also the instructions for

the woodworking machine connected to

the dust collector.

− Electrical hazard:

Operate the machine only on a

power source matching the following

requirements :

Protection against electric shock by

an residual-current device (RCD) of

30 mA sensitvity;

outlets properly installed, earthed

and checked.

Use only cables with at least

1.5 mm

2

lead cross-section.

Do not pull on power supply cable to

unplug.

− Hazard generated by machine

faults:

Do not operate the machine with a

faulty part. Replace damaged parts

at once! Do not make any changes

to the machine.

− Fire hazard:

Do not vacuum any hot objects (e.g.

chips generated by cutting metals).

− Hazard generated by uninten-

tional starting of the machine:

Unplug the dust collector before

emptying the dust bag.

Unplug when the dust collector is

not in use.

− Risk of injury by inhaling wood

dust:

Dust of certain timber species (e.g.

oak, beech, ash) can cause cancer

when inhaled. Wear a dust mask

when emptying the dust bag. Dis-

pose of the dust bag’s contents in an

ecologically safe way.

,

• Easily portable by pull-out handle

and two integrated wheels.

• Additional feet on one side to posi-

tion the dust collector in a upright

position to save floorspace.

1. Lift combination machine at the car-

rying frame (1) and place it on the

rubber feet on its side.



Caution!

Always lift the combination

machineat the carrying frame only!

2. Install further four rubber feet (2) on

the underside of the combination

machine.

3. Attach four rubber feet (3) to the

side of the dust collector.

4. Place combination machine on the

dust collector.



Risk of squashing between

combination machine and dust

collector!

5. Turn the small diameter suction

hose (4) appox. 10 mm into the

branch piece (5).

6. Fasten the branch piece (5) as illus-

trated with the connection hose (6)

and two hose clamps to the chip

case (7).

7. Slide the short suction hose

(100 mm ∅) (8) from below onto the

branch piece (5) and secure with a

hose clamp.

8. Fit support bracket (9) to the groove

(10) of the machine table and

secure with screws.

9. Remove cap (11) from the saw’s

blade guard (12).

1. Safety

2. Special Product Features

3. Assembly

1

2

3

4

5

8

6

7

9

10

11 12

XW0007E2.fm Operating Instruction ENGLISH

1 2 3 4

Comments to this Manuals

No comments