Metabo P 600 Operations Instructions download pdf (Page 12)

ENG

discharge port) and ﬁ ll clean water through the discharge port into the casing, until it is completely ﬁ lled an all air

has vented. Reinstall vent plug and connect a pipe or hose to the discharge port.

With too little or no water the pump will not prime, running it dry will damage the duocone seal.

No warranty for a duocone seal damaged by silt or sand.

To prevent damage to the duocone seal check with your dealer for suitable ﬁ lters offered by Metabo.

If the pump does not start when new or not having been in use for a longer period, turn pump manually. With the

help of a screw driver put through the fan cover, turn motor fan until shaft has worked free.

Caution! Always disconnect from power before attempting to free shaft.

Note: Without a check valve the water level in the suction line can drop. This can cause damage to the pump

when it has to start priming again.

➔ Always install a check valve in the suction line. It is recommended to ﬁ t the check valve directly to the

pump's suction port.

➔ Use only hose couplings with adjustable collar to prevent the ingress of air (see accessories for

pumps).

5 Pump Characteristics

Delivery head (overall height)

Capacity in litre per minute (m≈/hour) at 1 meter suction head

1234

6 Maintenance

The centrifugal pumps P 600/1600 W and P 600/1600 D require no maintenance.

Important: If the unit is not installed in a frost-free environment proceed as follows when there is danger of tempe-

ratures falling below 0°C/32°F:

- empty pump completely by draining through the suction and delivery port. –

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Metabo P 600 Operations Instructions Page 12